Wish
DX  » Community » Forums
«See all threads (in Product Forum)
Product Forum

2048 steps/rev, some play

  • DrJones Saturday, May 19, 2012 3:02 PM Reply
    I got that little stepper today and connected it to the Arduino; pretty straight forward. Runs on the 5V from USB (to which I connected the Arduino).
    It takes 2048 full steps per revolution.
    Maximum speed is about 8 rev/minute in my config, that's about 270 steps/second.
    CON: The gears have quite some play, about 3° for mine :(
    Posts(1593) | Reviews | Tip post

  • angryflashguy Monday, June 4, 2012 7:20 AM Reply
    Which sketch did you use to test this? I'm using the "stepper_oneRevolution" example but the motor is only going clockwise. Any thoughts?

    Thanks in advance!
    Posts(1) | Reviews | Tip post

  • DrJones Monday, June 4, 2012 1:17 PM Reply
    You have to swap the stepper pin order to
    Stepper myStepper(stepsPerRevolution, 8,10,9,11);
    I used the knob example first and the played with it for a while.
    Also set
    const int stepsPerRevolution = 2048;
    and
    myStepper.setSpeed(8);
    Maybe that helps.
    Posts(1593) | Reviews | Tip post

  • dagbdagb Sunday, June 24, 2012 11:33 AM Reply
    DrJones!

    Thanks a bunch for the hints. Works awesome!
    Posts(7) | Reviews | Tip post

«Reply to this thread (in Product Forum)
Product Forum

Reply

Subject:

* 50 characters max

Message:

Please note: HTML codes are not allowed anywhere on this page (otherwise you will see an error).

Please note that DealExtreme Forums are not a sales or product support board. While we do constantly participate in this forum, please contact us via support ticket for a guaranteed fast response. We make every effort to make the quickest replies.

DX Everywhere