Wish
DX  » Community » Forums
«See all threads (in Arduino Enthusiasts)
Arduino Enthusiasts

programmer is not responding

  • pms16 Saturday, August 22, 2015 6:01 PM Reply
    I have bought UNO R3 Board Module + Ethernet Shield W5100 Module Integrated Board for Arduino. But I have problems to load a simple sketch, e.g. Blink to it through Arduino IDE.
    I get following messages:

    Using Port : COM5
    Using Programmer : arduino
    Overriding Baud Rate : 115200
    avrdude: stk500_recv(): programmer is not responding
    avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xdd
    avrdude: stk500_recv(): programmer is not responding
    ...

    Is there any documentation for this board (in english)?
    Posts(1) | Reviews | Tip post

  • Simonetti2010 Thursday, October 29, 2015 9:38 AM Reply
    The Ethernet shield uses pins 0 and 1 (which are RX and TX, respectively), which are also pins used by the ethernet shield. Because of this, the programmer won't work if the shield is installed.

    You need to disconnect the Arduino, remove the shield, reconnect, upload your sketch, disconnect, install the shield and then power the Arduino.

    Keep in mind that while the ethernet shield is being used, you won't be able to use Serial to print messages to the console.
    "I’m addicted to placebos. I’d give them up, but it
    wouldn’t make any difference." ............ Jay Leno



    Posts(1120) | Reviews | Tip post

«Reply to this thread (in Arduino Enthusiasts)
Arduino Enthusiasts

Reply

Subject:

* 50 characters max

Message:

Please note: HTML codes are not allowed anywhere on this page (otherwise you will see an error).

Please note that DealExtreme Forums are not a sales or product support board. While we do constantly participate in this forum, please contact us via support ticket for a guaranteed fast response. We make every effort to make the quickest replies.

DX Everywhere