Wish
DX  » Community » Forums
«See all threads (in Product Forum)
Product Forum

Any way to calibrate this?

  • Nuppi Tuesday, June 14, 2011 12:20 PM Reply
    I have 2 of these and the other is very accurate and working nicely.
    However the other one is giving false readings.

    Is there any way to calibrate this?

    Thanks.
    Posts(39) | Reviews | Tip post

  • dart16 Tuesday, June 14, 2011 12:41 PM Reply
    there's usually a pot inside....but I think it adjusts the crystal frequency.....so no..'fraid not.

    How far out and what ranges are out?
    Posts(979) | Reviews | Tip post

  • lukasandrysik Sunday, September 25, 2011 9:17 AM Reply
    you can calibrate it with pot inside. Just connect two multimeters to same voltage and turn it until it reads the same as reference meter.
    Posts(188) | Reviews | Tip post

  • James_C Friday, October 28, 2011 1:29 PM Reply
    ^ doing that, if it works at all, would only calibrate the one reading method and scale. Better question is why is the meter off calibration so much, there may be defect or damage.
    Posts(1699) | Reviews | Tip post

«Reply to this thread (in Product Forum)
Product Forum

Reply

Subject:

* 50 characters max

Message:

Please note: HTML codes are not allowed anywhere on this page (otherwise you will see an error).

Please note that DealExtreme Forums are not a sales or product support board. While we do constantly participate in this forum, please contact us via support ticket for a guaranteed fast response. We make every effort to make the quickest replies.

DX Everywhere