Involvement:Expert (understands the inner workings) - Ownership:1 day to 1 week
An excellent product and a best buy for the number of emitters per dollar. Bright white.
Easy for beginners to use as is, and cutable like the ribbon strips, at any three LED junction. There are good solder pads at each cut point if you wish to use shorter sections.
No cons since those arriving now are different to the one displayed in the customer picture and early revues. The soldering is good quality and the board design better.
75 LEDs protected every three LEDs with a 180 ohm resistor. This will make them bullet proof at charging voltages but tends to have them underdriven at 12 volts. There are still good and bright at that lower voltage however.
I measured 390 mA at 12 volts and another customer measured 590 mA at 14.1 volts.
Nominal rating at 12 volts would be 500 mA and 6 watts.
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.