-Very Clean Looking
-Doesn't cost a lot
-Able to adjust the arm length both sideways and forward(in case your phone is thick).
-Easy to clip on vent(push in, then push upwards and it should snap on.)
-Or you can just not use the springs that clip on the vent and instead use double sided tape to a...
-Very Clean Looking
-Doesn't cost a lot
-Able to adjust the arm length both sideways and forward(in case your phone is thick).
-Easy to clip on vent(push in, then push upwards and it should snap on.)
-Or you can just not use the springs that clip on the vent and instead use double sided tape to tape it somewhere on your dashboard
-Amazing, the iPhone charger cable fits through the legs of the mount perfectly, unless you have some aftermarket cable that has a fat head. SKU 19148 works fine. -Does NOT fit iPhone, the arms are 1-2cm too short for the iPhone, BUT I ghetto rigged it to fit my iPhone, read my Other Thoughts section.
-Bottom leg that phone sits on could be a bit longer
-I got the gold one =/ This is how I ghetto rigged to fit iPhone
-Unscrew, open up and remove arms that hold phone
-Take the plastic from container that this came in
-Now cut horizontally across the top, and cut out a rectangle piece that has same height as the arms
-Put plastic piece in middle of the mount where arms use to be and tape it down in the middle. Using 2 plastic pieces on top of each other will reduce bending of the plastic.
-Screw back on
-Put arms as close as you can to the mount on top of the plastic and tape arms onto the plastic
~I used clear tape so it doesn't look bad -Great if it fits your phone, or if you're able to modify it to fit your phone
-Now I can use GPS on my iPhone and put it on the mount and charge at the same time.
Read more
-Very Clean Looking -Doesn't cost a lot -Able to adjust the arm length both sideways and forward(in case your phone is thick). -Easy to clip on vent(push in, then push upwards and it should snap on.) -Or you can just not use the springs that clip on the vent and instead use double sided tape to a... -Very Clean Looking -Doesn't cost a lot -Able to adjust the arm length both sideways and forward(in case your phone is thick). -Easy to clip on vent(push in, then push upwards and it should snap on.) -Or you can just not use the springs that clip on the vent and instead use double sided tape to tape it somewhere on your dashboard -Amazing, the iPhone charger cable fits through the legs of the mount perfectly, unless you have some aftermarket cable that has a fat head. SKU 19148 works fine. -Does NOT fit iPhone, the arms are 1-2cm too short for the iPhone, BUT I ghetto rigged it to fit my iPhone, read my Other Thoughts section. -Bottom leg that phone sits on could be a bit longer -I got the gold one =/ This is how I ghetto rigged to fit iPhone -Unscrew, open up and remove arms that hold phone -Take the plastic from container that this came in -Now cut horizontally across the top, and cut out a rectangle piece that has same height as the arms -Put plastic piece in middle of the mount where arms use to be and tape it down in the middle. Using 2 plastic pieces on top of each other will reduce bending of the plastic. -Screw back on -Put arms as close as you can to the mount on top of the plastic and tape arms onto the plastic ~I used clear tape so it doesn't look bad -Great if it fits your phone, or if you're able to modify it to fit your phone -Now I can use GPS on my iPhone and put it on the mount and charge at the same time. Read more
0 0
ViewMore
Hide