DX » Community » Reviews » 650nm Laser Diode Module for Arduino (Works with Official Arduino Boards)
  • 5 star 2 ( 33% )
  • 4 star 4 ( 67% )
  • 3 star 0 ( 0% )
  • 2 star 0 ( 0% )
  • 1 star 0 ( 0% )
Customer’s impression:
There are no customer's impression yet.
Create Review

Share your thoughts and
Get DX Points!

  • Does its job

    posted by DerBunman on 10/09/2012

    Involvement:General (knows how to use it) - Ownership:1 day to 1 week


    Cheap and ready soldered laser.


    Laser is not so bright. Can not be seen good after like 4 meters. The spot seems a bit scraggy.


    As with all DIY parts on DX there is no manual.
    So I found out (searched the web) you have to wire minus to the pin labeled "-" and an 333Ohm resistor to "S" and then attach plus to the resistor. Without resistor the laser wouldn't stand a minute.


    I don't know yet for what I will use my laser, but I think every (mad) scientist should have at least one laser.

Post comment


Get great weekly deals and offers like: Collections