DX » Community » Reviews » Prototype Universal Printed Circuit Board Breadboard - Golden (10-Piece Pack)
Customer’s impression:
good Ótima Ideal for small electronic projects
Create Review

Share your reviews,
photos and videos here!

Sort by
  • Latest Reviews
  • Most Helpful Reviews
  • Pro Reviews First
  • posted by8588856 on 06/27/2015

    Produto muito bom vale apena.


    0 0 0

  • posted byWolfAlexWolf on 02/08/2015

    Pros: Affordable , good quality / price ratio . Ideal for small electronic projects. A good quality product and copper is easy to weld and good dimension.

    Impression:Ideal for small electronic projects;

    0 0 0

  • posted byEddie123 on 01/20/2015

    Good looking small print board. The solder points are a bit small, so difficult to get a good solder, but it works. Too bad DX dotn sell veroboard or stripeboard, much more useful than these where you have to use wire to connect everything.


    0 0 0

  • posted byShevshenko on 10/28/2014

    Ótima placa, muito boa para fazer circuito. Ajuda muito quando preciso fazer um circuito rápido.


    0 0 0

  • posted bysolidraven on 12/22/2013

    - Regular hole pitch - Good heat resistance - Copper doesn't delaminate from substrate too quickly after excessive heating - Islands are close enough to form solder bridges - You can get spacers that fit in these holes - Copper is slightly oxidized, needs flux or a quick etch bath if you're using... Read more

    0 0 0

  • posted byledlek on 11/01/2013

    It has exactally the size to make your DIY Arduino UNO on perfboard (ATMega 328 + voltage regulator + FTDI headers) The board size fits on any case that fits an Arduino. Good for general small circuits of sensor and leds for your Arduino project. It has four holes on the corners, good for Great I... Read more

    0 0 0

  • posted byJumboman on 08/25/2013

    this is very nice to have if you know how to solder. I have a couple of projects that need complicated resistor line-ups and it's nice to just solder the whole damn thing together and never having to set it up again. the solder doesn't stick to it very well. this could be due to my lack of skill... Read more

    0 0 0

  • posted byRBMK9000 on 01/03/2013

    This is ideal for making small batch of prototypes of something and it's price is unbeatable. It has printed grids, so you can't get lost on it. Holes are with good quality. bigger copper islands would be better, but with the smal ones the solder is not making annoing crosses. You can make just... Read more

    0 0 0

  • posted bytylernt on 10/09/2012

    Standard prototyping perfboard. They do not have "breadboard" style strips though, just individual holes (adjacent holes can be bridged with extra solder). These are the cheapest I was able to find on DX. Just that because they're made of phenolic, not fiberglass, so they are a little a... Read more

    0 0 1

  • posted bybodangles on 09/20/2012

    Simple board with 0.100" spacing. Fits any through-hole IC/component which uses 0.100" spacing for it's pins. It comes in a pack of 10 for use in many projects. Comes with a letter or number for each row/column which makes it easy to build multiple of the same board by allowing you to a... Read more

    0 0 0

DX Everywhere