Excellent sensors for measuring environmental temperatures inside or outside housing.
Can stand heat excelently and seems to be precise.
I ordered 2 to use with Raspberry Pi Zero. Can be used with 1-wire setup with multiple sensors simultaneously. Don't forget to buy a 10k ohm or 4.7k ohm pull up resistor.
As it seems to take some time for the chip to provide accurate measurements it seems to take from 500ms to 750ms to read the sensor. Also, it takes time for heat to transfer so it can be accurately measured approximately even from 5 to 10 seconds so this product is NOT suitable for situations where rapid measurement is required!
Works perfectly for me. I think about ordering couple more!
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.