Involvement:Expert (understands the inner workings) - Ownership:1 day to 1 week
Very small and neat. Comes all packaged in a real antistatic bag. No analog input! VID: 08A9 PID: 0014 ATMEL 24c02N SU27 hardwired for I2C read address A0 NXP 74HC245 100K pullups with 100R series hardwired as permanent input buffer, so no output. CH0 (not CH1 as labeled) is monitored after the buffer with an LED that lights when is pulled to ground. Based on Cypress FX2 CY7C68013A-56PVXC AMS1117 3.3V NOKIA DKE-2 mini USB cable Single pin female connectors on a colored flat cable.
PCB designed with vias over pads on an ugly ground track where some solder joints are barely done. USB input fuse is a 0R resistor. A few decoupling caps and USB shield connecting parts to ground are missing.
Label is misaligned with the LEDs. The PCB is loose inside the tiny box and rattle a bit. Would've nice if one end of the flat cable used a 10 pin IDC connector instead of the individual pins but are easy to tape all together anyway.
Easy to open. No screws. Just pull the top from the 10 pin connector side.
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.