DX » Community » Reviews » 2 Channels DC Stepper Motor Driver Module for Arduino (Works with Official Arduino Boards)
5.0
  • 5 star 2 ( 67% )
  • 4 star 1 ( 33% )
  • 3 star 0 ( 0% )
  • 2 star 0 ( 0% )
  • 1 star 0 ( 0% )
Customer’s impression:
There are no customer's impression yet.
Create Review

Share your thoughts and
Get DX Points!

Sort by
  • Latest Reviews
  • Most Helpful Reviews
  • Pro Reviews First
  • posted bySamiVakkuri on 08/19/2013

    Great circuit for controlling two DC-motors (or stepper motor). I use it with 12V battery and Arduino Mega to control ~20W motor and it works properly. No information about working. You need to know how L298 H-bridge works. (Example datasheet: https://www.sparkfun.com/datasheets/Robotics/L298_H_Bridge.pdf) Here example about working: A1: A2: Motor state:... Read more

    3 0
  • posted byGigaSan on 06/21/2013

    This controller is not only for stepper motors but can control one stepper or two regular DC motors. Protection diodes, indicator LEDs, power supply (5V and 3.3V), all are present on the board. Works perfectly with anything between 4V and 15V. Inputs need to be connected to 4 Arduino output pins. None at all. Based around a well known double-H bridge ... Read more

    2 0
  • posted byfabio1964 on 03/26/2013

    This is a very nice little L298 carrier board. It has (very bright) red status LEDs for the 4 inputs, as well as jumper-enable-able pull-up resistors on the inputs. No data sheet or documents come with the board so you must do a little research to figure everything out, especially if you are not familiar with h-bridges like myself . The screw terminals ... Read more

    4 0

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections