It works perfectly. Just place your original card, press read button, place your empty new card press to write button and that's all! There is an extra hole near housing. Bad quality of the housing. Mine was closed with a semi-hard plastic tape but maybe it's not a con. Also be careful when you remove ... Read more
Works fine, as expected. Used it for making a clone of parking-entrance card.
Usage is very simple, as someone above says.
The left button is for reading, the right one for writing. Came with one blank card only, no keychain included!
Some open casing holes around the box. As other say, use adhesive ... Read more
Shocked, worked on an RFID tag for a parking spot I'm renting. Was even able to reprogram one I found so counting the two the unit came with I have three extra's Had to come back to this site to figure out how to work it.
-Current no cards in stock, only the keychain's
:( Worked for me, was hoping (though ... Read more
IT WORKS and its simple to use! 1)Place source card 2)Press read button 3)Place destination card 4)Press write button *)You can perform step 3-4 over and over... to write multiple cards at once (e.g. for RFID controlled car parking), also after step 4 you can also step directly to step 1 and do more ... Read more
Works fine for all 125khz tags tested and it can run on a 9v battery. It's simple to operate. Will not clone HID RFID tags (but it never says that it will and I don't think its even technically possible). Also I think the price is a bit high and the unit could be a bit smaller than what it is. It's a ... Read more
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.