DX » Community » Reviews » 4-Mode 6A LED Driver Circuit Board for 2 or More XM-L Bicycle Headlamp / Flashlight (7~18V)
Customer’s impression:
misleading description gostei otimo produto
Create Review

Share your reviews,
photos and videos here!

Sort by
  • Latest Reviews
  • Most Helpful Reviews
  • Pro Reviews First
  • posted byFoye777 on 12/17/2015

    This is a 1.5A boost driver not a buck driver! This means that the input voltage as to be lower than the output voltage drop otherwise it will fry. If you want a driver that can be hooked up to a car battery (13.6v) and expect to run 2 XML in parallel at 3A each (or 2 strings of 3 XM-L in this do... Read more

    Impression:misleading description;

    0 0 0

  • posted byLinuspower on 08/17/2014

    pross: chegou, funciona recomendo contrass eu queimei a peça antes de testar

    Impression:gostei otimo produto;

    0 0 0

  • posted bycyclomiha on 07/07/2014

    - No annoying flash-mode when switching between modes. - With long press, while light on, it is possible to adjust brightness of each mode from 10%-20%-30%....100% - Decent price - Consumes 15mA while switched off. - No overheat protection Tested with different amount of LEDs on series. Input 7 6... Read more

    3 0 1

  • posted byjarbat on 02/09/2014

    It has four modes that can be set in ten different brightness levels and a hidden flashing mode. The light fades from one mode to another. No instructions provided It would be useful to know all of it's capabilities. I learned about the driver possibilities in the forum I have installed it on a 5... Read more

    0 0 0

  • posted byvaldasbiel on 01/06/2014

    Driver board is suited to work with 4,5,6 XML's connected in series with output on high about 1~1.2A. It has three modes on cycle press and hidden flash. You can set any of three modes choosing from 10 levels of brightness. It has low voltage warning turning red status on. Then turned off eats To... Read more

    2 1 5

  • posted bycyclomiha on 11/06/2013

    With 6 LEDs; low=0.20A, med=1.33A, hi=3.0A With 5 LEDs; low=0.34A, med=1.25A, hi=2.32A With 4 LEDs; low=0.47A, med=1.18A, hi=1.71A Values measured between PSU and board. Power supply provided 8.4VDC. All LED's on series With 7 LEDs; low=0.06A, med=0.28A, hi=0.64A Values measured between PSU and 6... Read more

    1 0 1

  • posted byLtngStlkr on 10/18/2013

    6A Theoretical Output RGB LED Indicators Decent Price The large aluminum electrolytic capacitor overheats Part numbers scratched off major components The switch placement is odd. The driver would have to go in the tailcap to use the switch as-is and wires run to the LEDs at the front. It's better... Read more

    0 0 0

DX Everywhere