Finally a cree module that seems to put out as much lumens as it is advertised,I have actually been useing two cr123a batteries and it hasnt blown (yet?)easy to install and I think this would fit any torch with a 26.5 diameter module,ive bought a few at different sites and thisw is just as bright as ... Read more
XP-E emitter, easy drop in for P60 ready lights. Mode memory for last mode used. Nice tight spot with sufficient flood. OVERDRIVEN! With a single Li-on, don't know how long it will last. Driver board a little hinky; when activated, has about a 1/4 second delay before anything happens (same with mode ... Read more
If your looking for a low current draw drop in that can throw , then this is the best you can buy ATM . 4.2v Please , I bought this for single CR123A use , I did not want 8.4v . I put this in my Ultrafire 501A for use with single RCR123A , and it is a combo worth having I can tell you . Very low current ... Read more
This drop-in is great.
Very bright with one 17670.
Due to the XPE package being small it deliver a tight beam around 15* hot spot and 18* corona with the stock reflector but using a XRE reflector it delivers a 40* wide beam when set .6mm back from the reflector, 32-35* beam at 1.2mm back and 23-25* beam ... Read more
It is a straight drop in for P60 type.
Memory mode works.
That's it. Tint is slightly blue to yellow, not white.
Tested and compared against SKU 14442 (Cree R2-WC 250-Lumen 5-Mode Memory Drop-in LED Module (3.6V~8.4V)using;
1. 1 x 16340 = SKU 14442 is better.
2. 1 x 18650 = SKU 14442 is better.
3. 2 ... Read more
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.