Involvement:General (knows how to use it) - Ownership:1 week to 1 month
is a good product, but is a bit small, which makes it better for heat dissipation to the filament. diameter of 0.3 mm output is good but if you want better print resolution should look for a 0.1 mm, remembering that will take longer to print.
I had to remove the brass entry because the output of the extruder my printer had no room to fit it, but no problem.
Because I already had the filament 3mm, had to buy this nozzle. but if you have not bought the filament, I recommend you buy the filament and nozzle with inlet 1.75 mm, because the time required to melt the filament. The larger the diameter of the filament, the more time consuming to melt it, even a few seconds.
Recommend to insulate with kapton tape or Teflon tape, used to seal commonly water pipes and taps. Perhaps the appearance not be good, but it will help you a lot against heat loss from the nozzle.
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.