DX » Community » Reviews » AV-0.14A 12V 2-Pin HDD 30-Blade Cooling Fan - Black
Customer’s impression:
good quiet airflow
Create Review

Share your reviews,
photos and videos here!

Sort by
  • Latest Reviews
  • Most Helpful Reviews
  • Pro Reviews First
  • posted byairgunnut on 08/21/2017

    Impression:good,quiet,airflow;

    I am impressed with this fan, using .014A it moves a surprising amount of air, its also quiet. one little thing i noticed, the air flow, it does not exit the fan at 90 degrees to the housing, with the fan stood vertical and the square exit at the top parallel to the table, the air will flow down.... Read more

    25 0

    ViewMore Hide

  • posted byGoku007 on 09/18/2016

    Impression:good;

    Just what I was looking for my 3d printer layer fan. Small, light, enough airflow.

    5 0

    ViewMore Hide

  • posted by10201020 on 03/29/2016

    Impression:good,quiet,airflow;

    Very good fan for my 3D printer, quiet and good cooling for PLA. Only CON is very short cable (25cm).

    0 0

    ViewMore Hide

  • posted by9135734 on 01/08/2016

    Impression:good,quiet,airflow;

    Fast delivery. Nice and quiet fan. I will use it with my 3D printer, the speed is well controllable. Connector fits fine.

    0 0

    ViewMore Hide

  • posted byKriLL3 on 08/06/2015

    Impression:good,quiet,airflow;

    Pros: Very good airflow at very reasonable noise level. Operating voltage is 2.7v to 12v+ (will overheat sitting at 14+) I suggest not running it above 13~ I'll use it as a print cooling fan on my 3d printer for which it's ideally suited. Cons: No real cons to mention.

    0 0

    ViewMore Hide

DX Everywhere