DX » Community » Reviews » 3.6V 5-Mode 3W Circuit Board for Flashlights (1000mA 3.7V Output/2-PCS)
5.0
  • 5 star 1 ( 25% )
  • 4 star 2 ( 50% )
  • 3 star 1 ( 25% )
  • 2 star 0 ( 0% )
  • 1 star 0 ( 0% )
Customer’s impression:
There are no customer's impression yet.
Create Review

Share your thoughts and
Get DX Points!

  • WoW with a 14mm Q5 on a RC-G2

    posted by callmeshyguy on 09/08/2008
    0

    Involvement:Expert (understands the inner workings) - Ownership:more than 1 month

    Pros:

    Well It was easily sautered in because it fits in a AA pill esp. Romisen G-2. The mode is a bright high maybe 700-800mA and a low maybe 350mA not to low though as i would of liked. A slow strobe, then fast strobe, then that annoying 10-sec beacon yes 10 second not SOS. Its a 3.7volt input, I tried 1.5v no luck oh well. I tried this one after another driver with the brass spring broke (IC Chip underneath broke it was 17mm)

    Cons:

    Limited voltage but try a 14500 and it will work great. Looked thin almost transparent but works great.

    OtherThoughts:

    Gives my UF 502B R2 a run for its money. I cant believe I created a little throw monster. Maybe more than 250 lumens

    Bottomline:

    A good driver definately close to advertised "1000mA". Try it you'll love it. 5 modes better than 20 modes simple and no need to sand down even fits AA pills by depth too.

Post comment

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections