2 DXPoints earned for this post
write a review, and get DXPoints
© 2006~2013 DX.com. All rights reserved.
Note:Stock and Availability shown on this site is for your reference only. While
we strive to provide the most accurate and timely stock and availability information,
availability information may become out of date and may change between the time
you added an item to cart and the time your order is received.
Quantities on clearance items are limited. Prices are current at time of posting. DX Reserves the right to change prices at any time without notice.
Partners: Volumerate l MadeinChina l 寻求供应商

posted by kbcaum on 04/04/2009 Certified Owner
Involvement:Expert (understands the inner workings) - Ownership:1 day to 1 week
-It has the enough flux to absorb the solder; You don't need to use extra flux like some bad quality wicks.
- Pay attention to the 2mm width, depends the amout of solder to remove the 1.5mm or 2.5mm width would do it better.
Very useful to remove the excess solder from fine pitch SMT components.
You should get some Isopropanol to keep your work clean.
Probably in the next order I will try the 2.5mm width.
Thank you DX!!!