Wish
DX » Community » Reviews » MrDotSneezy's reviews
Sort by
  • Latest Reviews
  • Most Helpful Reviews
  • Pro Reviews First
  • First look at the radio

    posted byMrDotSneezy on 02/10/2012

    Band limits are UHF 400-480Mhz as advertised (no VHF). My purchased units performance below as measured with a fully charged battery. TX power as measured : 400Mhz = +37.5dBm (5.6W) 440Mhz = +37.4dBm (5.5W) 480Mhz = +36.5dBm (4.46W) No problems or... Read more

    0 0

    ViewMore Hide

  • Good for me

    posted byMrDotSneezy on 06/19/2010

    I took a risk and bought the server to use with an unsupported printer. The risk paid off nicely as it indeed works with my Samsung CLP-300 laser printer just fine. I tried to be clever and configure the device myself, but after 30 minutes I just... Read more

    1 0

    ViewMore Hide

  • PowTech PT4115 based LED driver module

    posted byMrDotSneezy on 06/05/2010

    The module is based on the PowTech PT4115 step-down LED driver, with 5000:1 Dimming via PWM if needed. Input voltage is really 8-30V. Current is set by the only resistor on the module. I put in a 1ohm, which gives 100mA instead of 650mA. So it can... Read more

    0 0

    ViewMore Hide

  • Good light for general use

    posted byMrDotSneezy on 01/19/2010

    Anodized finish is very nice, as good or better than my Mag light. The three O-rings seal the case up well too. Glass lens. Solid feel to the clicky switch. No modes, just ON-OFF. Threads cut quite well, screws together smoothly. Tail stands fine.... Read more

    0 0

    ViewMore Hide

  • Great DS Lite case

    posted byMrDotSneezy on 01/18/2010

    Very nice hard gloss finish. Fit of all parts into this case was very good. No trimming was needed. Supplied screw set was a little smaller, easier to fit. Screws too replace the tri-wing types with Philips. None found yet. No time to think, too... Read more

    0 0

    ViewMore Hide

DX Everywhere